top of page

TERMS & CONDITIONS

The information including all the dimensions and specifications given was correct at the time of publication, however, EASYCUT ltd reserve the right to correct any misprint before an order is placed unless otherwise agreed, payment in full is required before delivery. Where EASYCUT agrees to 30 days credit terms, the invoice must be settled by the due date; otherwise, any remaining balance will incur interest at 8% over the rate set by National Westminster Bank PLC until the balance is fully settled. Subject foregoing, all conditions, warranties and representation expressed or implied by statue, common law or otherwise in relation to the products (apart from terms implied as to the title under the sale and supply of goods act 1994) damage or injury directly resulting from defective products or material, faulty workmanship or otherwise how so ever arising and whether or not caused by the negligence of EASYCUT LTD, its employees or agents save that EASYCUT LTD accepts no liability for death or personal injury caused by negligence of EASYCUT LTD.

Subject to any special terms agreed in writing between the buyer and the seller, the buyer shall pay the price of the goods when placing its order by credit or debit card or electronic bank transfer. In the event that the buyer seeks recovery of the price of the goods from the credit company that facilitated the buyer’s payment for the goods where the buyer is not entitled to a refund under these terms and the seller has to re-pay to the credit card company concerned the price of the goods, then in addition to the rights set out at clause 1.0 below, the seller may re-invoice the buyer for the price of the goods and any administration fees incurred by the seller in such circumstances and any such invoice raised shall be payable in accordance with the clause below. In all other cases, the buyer shall pay any other amounts invoiced to it by Seller pursuant to these terms within 30 days of the date of the seller’s invoice, and the seller shall be entitled to recover the price, notwithstanding that delivery may not have taken place and the property in the goods has not passed to the buyer. The time of payment of the price shall be of the essence of the contract. Receipts for payment will be issued only upon request.

1.0 If the buyer fails to make any payment on the due date, then, without limiting any other right or remedy available to the seller, the seller may;

1.1 Cancel the contract or suspend any further deliveries to the buyer

1.2 Any payment made by the buyer to such if the goods (or the goods supplied under any other contract between the buyer and seller) as the seller may think fit (not with standing any purported appropriation by the buyer); and charge the buyer interest (both before and after any judgment) on the amount unpaid, at the rate of 8% over the rate set by National Westminster Bank PLC, until payment in full is made (a part of a month being treated as a full month for the purpose of calculating interest). The buyer shall indemnify the seller against all costs and expenses incurred by the seller (on a full indemnity basis) in recovering or seeking to recover any sums due to the seller which are not paid to the seller in accordance with the provisions of this clause.

WARRANTY & CONDITIONS

Most of the goods supplied by EASYCUT LTD are under the manufacturers’ one-year back-to-base and parts-only warranty (unless otherwise stated or agreed and from the date shown on the invoice). The warranty applies to the UK mainland only. The warranty does not apply to glass, light bulbs/tubes, blades, wear and tear, or damaged or misused items. In the event of a breakdown within the one-year warranty period, we will supply all necessary parts to you, if any units are redeemed unfit by our engineer and need replacing warranty will remain from the original purchase date and will not restart. If the product is carrying back to the base warranty, the customer must send the item back to where EASYCUT LTD assigns the address to be. The cost of delivery will be customer’s responsibility.

 

The warranty becomes invalid if non-approved parts are fitted and if the equipment is used other than for its designed purpose. The warranty is not transferable and lies with the original purchaser and the site address to which the goods were delivered to.

The warranty becomes invalid if non-approved parts are fitted and if the equipment is used other than for its designed purpose. The warranty is not transferable and lies with the original purchaser and the site address to which the goods were delivered.

DELIVERIES

Our standard delivery is made by one driver and usually takes 2-3 working days for the UK mainland and excludes surrounding islands (on certain postal codes in Scotland delivery charges may apply) and includes off-loading only. It is the customer’s own responsibility to take the goods indoors,

Therefore, it is advisable that customer checks with their dealer, what if any special conditions apply to the product being purchased. Please note it is your responsibility to check that the goods physically fit the site, should you have any queries regarding access, etc. Please contact our transport department and we will do our best to assist.

All goods must be checked and signed for by the customer upon delivery as EASYCUT LTD will not take any responsibility for damage to goods if signed for by the customer as unchecked.

All deliveries are subject to there being a reasonable place for parking and unloading of the vehicle. Should a site survey be required, this can be done by us for a small charge.

For 2-man deliveries please allow 3-4 working days and consists of taking the goods inside, removal of the packaging, and positioning of the goods and excludes any glass assembly. To save unnecessary charges it is the dealer’s responsibility to carry out site checks prior to delivery to check for any obstructions which could lead to an aborted delivery, for further information on obstructions please call the office on 0113 270 22 11.

 

Restocking charges: There will be a minimum of 25% re-stocking charge for any aborted deliveries that have occurred due to no fault of EASYCUT LTD.

35% restocking charge applies to the parts and items that cost less than £400.00 plus the cost of delivery.

There will also be a minimum of 50% charge for the special orders and non-stock items. In addition, goods must be returned to our warehouse in its original packaging undamaged, by the customer.

NEXT DAY & SPECIAL DELIVERIES

Next-day and timed deliveries are available at an extra cost, for next day deliveries orders must be placed before 12pm, for changes please call the office on 0113 270 22 11 or sales@easy-cut.co.uk

TECHNICAL INFORMATION SPECIFICATIONS AND APPEARANCE

Whilst every effort was made to verify the technical information in this website and our catalogs, EASYCUT reserve the right to change specifications, model number, and appearance of any model without prior notification. We cannot, therefore, be held responsible for any such changes following the production of a new catalog.

INSTALLATION

All cooking equipment must be installed, fitted, and maintained by qualified engineers. A gas-safe certified engineer must be employed where a gas appliance is fitted, and a qualified Electrician must be employed to fit any electrical appliance.

UK WEEE REGULATIONS

UK WEEE Regulations: SI2006/3289 Waste Electrical and Electronic Equipment Regulations 2006 as modified by any subsequent legislation.

FUTURE WEEE

EASYCUT sells its products either by retaining the producer’s obligations under the WEEE regulations or with customers taking on those responsibilities. In either case, the customer must clearly state which of these options they require, and this must be documented.

The customer must agree to disclose this agreement to any subsequent purchaser(s) of this equipment, as required by regulations.

HISTORIC WEEE

The Customer agrees to accept full responsibility for EASYCUT obligations under the WEEE Regulations which require EASY CUT to be responsible for financing the collection, treatment, recovery and environmentally sound disposal of any product supplied before 13th August 2005, where a similar new product is being purchased.

EASYCUT LTD will undertake the collection, treatment, recovery, and environmentally sound disposal of any product supplied before 13th August 2005 (or outside the scope of the WEEE Regulations) subject to payment of its current disposal fees.

bottom of page